Table of Contents
Advertisement
Disassembling the rear brake control
The brake master cylinder is supplied only as a complete unit; internal components cannot be replaced.
To disassemble the master cylinder's outer parts, follow the indications given in the exploded view at the
beginning of this Section.
If the bush (10) inside the brake pedal (6) needs to be replaced, grease the external surface and fit the
new bush using a press to insert it. The bush must be placed at 2 mm from the pedal external face.
To disassemble the various parts of the system, refer to the exploded view at the beginning of this chapter.
After performing an operation on the rear brake control, check the brake pedal position following the
instructions detailed in Section
"Adjusting the position of the gear pedal and rear brake
pedal".
Advertisement
Table of Contents
