Controls On Left-Hand Switch - Ducati SCRAMBLER 800 Workshop Manual

CONTROLS ON LEFT-HAND SWITCH

HORN button (2)
Connect the terminals of a multimeter to the Yellow and White/Blue cables to check for electric continuity,
which must be available when HORN is pressed.
- When the HORN button is pressed, the resistance value read by the multimeter should be close to zero
and, if available, a continuity beep should be heard.
- When the HORN button is not pressed, the resistance value should be infinity (there is no continuity as
the electrical contacts inside the push-button are open) and no continuity beep should be heard, if provided.
If these conditions are not met, the device must be replaced.
Turn indicator switch (TURN) (3)
The turn indicators cancel button may also be used in the instrument panel for the CONFIRM MENU
function, for selecting the riding mode.
Push this button for 3 seconds to the left side to activate the "Hazard" function (all 4 turn indicators).
Connect the multimeter to the Red/Blue and Grey wires arriving from the turn indicator switch and check
for electrical continuity when operating the right turn signal.
Repeat the above procedure for the left turn indicator, but connect the multimeter to the Black and Grey
wires.
Control switch (SET UP) (SET DOWN) (4) (5)