Changing The Rear Phonic Wheel Sensor; Removal Procedure; Refitting Procedure - Ducati SCRAMBLER 800 Workshop Manual

Changing the rear phonic wheel sensor

REMOVAL PROCEDURE

Disconnect connector (1) of rear ABS sensor from electric wiring. Open all clips retaining rear ABS sensor
cable: refer to tables under Section "Routing wiring harnesses /
hoses".
Remove the rear ABS sensor (2) from its seat on rear calliper holder plate (3), by loosening retaining screw
(4) and collecting calibrated sealing washer (5). Check air gap between new rear ABS sensor (2) and rear
phonic wheel as explained under: "Adjusting the AIR-GAP of phonic wheel sensor". Fasten the sensor to the
calliper holder plate by tightening screw (4) to a torque of 7 Nm ±10%.

REFITTING PROCEDURE

Connect connector (1) to main wiring. Fasten all clips retaining rear ABS sensor cable: refer to tables under
Section "Routing wiring harnesses /
hoses".