Table of Contents
Advertisement
Removing the rear brake calliper
Warning
The brake master cylinder manufacturer advises against servicing the brake master cylinder due to the
safety critical nature of this component. Incorrect overhaul can endanger rider and passenger safety.
Maintenance operations on these units are limited to replacement of the following parts: control lever, fluid
reservoir assembly and relative fasteners and master cylinder fasteners.
Drain the rear braking system
(Changing the rear brake system
fluid).
Loosen special screw (1) without removing it.
Remove the rear wheel
(Removing the rear
wheel).
Undo and remove the special screw (1) securing the hose (2) to the rear brake calliper and the
corresponding seals (3).
Remove the hose (2).
Slide out calliper (4) from calliper holder (5).
Advertisement
Table of Contents
