Table of Contents
Advertisement
Pin Code
This function allows enabling and then modifying a 4-digit PIN code to "temporarily" start the vehicle in
case of Immobilizer system malfunction.
The PIN CODE is initially not present in the motorcycle, it must be activated by the user by entering his/her
4-digit PIN in the instrument panel, otherwise the motorcycle cannot be started temporarily in the case of a
malfunction. To activate this function, refer to "Entering the PIN CODE" procedure.
To change the PIN refer to "Changing the PIN CODE" procedure.
In order to temporarily start the motorcycle in case of malfunction of the Immobilizer system, please refer
to the "Vehicle Release" procedure.
Warning
The motorcycle owner must activate (store) the PIN code; if there is already a stored PIN, contact an
Authorised Ducati Dealer to have the function "reset". To perform this procedure, the Authorised Ducati
Dealer may ask you to demonstrate that you are the owner of the motorcycle.
Entering the PIN CODE
To activate the PIN CODE function and enter your own PIN CODE you must open the SETTING MENU.
Select PIN CODE option, by pressing button (1) or (2). Once function is highlighted, press CONFIRM MENU
button (4).
Note
If upon accessing this function, the "O : " (Old) indication is displayed together with four flashing dashes "-
- - -", a PIN code is already stored and the Function is already active.
When accessing the function, the display will show "N:" (new) followed by four flashing dashes "- - - -".
To go back to the previous indication without activating a PIN CODE, press button (2); as soon as the
"EXIT" box starts flashing, press button (4) again.
Entering the code:
Press button (4), only one digit indicating "0" starts flashing;
1
Each time you press button (2) the displayed number increases by one (+ 1) up to "9" and then starts
2
back from "0";
Each time you press the button (1) the displayed number decreases by one (- 1) up to "1" and then
3
starts back from "0";
To confirm the number, press the button (4);
4
Repeat the procedures until you confirm all the digits of the PIN CODE.
Press button (4) to confirm the fourth and last figure: the 4-digit code starts flashing.
To memorise the entered PIN, keep button (4) pressed for 3 seconds.
If new settings have been saved, "MEM" will be shown and the "EXIT" box will be flashing.
To quit, press button (4).
Once the first PIN CODE is stored, this menu page is no longer available and is replaced by the page for
changing the PIN CODE.
Advertisement
Table of Contents
