Refitting The Front Footpeg Support; Lh Footpeg Holder - Ducati SCRAMBLER 800 Workshop Manual

Hide thumbs Also See for SCRAMBLER 800:

Table of Contents

Refitting the front footpeg support

If previously removed, lubricate the two vibration damping pads (19) with specified product and position

them as shown in the figure.

Use a suitable press to fit the silent block (20)

Position the footpeg holder on the frame.

Start the screws (2) and (3) retaining footpeg holder to the frame.

Start screw (4) securing footpeg holder to exhaust.

Tighten the screws (2) to a torque of 36 Nm ± 10%.

Tighten the screw (3) to a torque of 55 Nm ± 5%.