Removing the rear brake control
Warning
The brake master cylinder manufacturer advises against servicing the brake master cylinder due to the
safety critical nature of this component. Incorrect overhaul can endanger rider and passenger safety.
Maintenance operations on these units are limited to replacement of the following parts: control lever, fluid
reservoir assembly and relative fasteners and master cylinder fasteners.
Drain the rear braking system
(Changing the rear brake system
fluid).
Remove the footpeg holder plate.
Disconnect rear stop switch (1) from main wiring.
Loosen rear brake master cylinder retaining screws (2). Slide out rear brake master cylinder (3) from
adjuster rod (4).