Engine Stop Button; Starter Button; Rear Stop Switch; Rear Stop Switch Control - Ducati SCRAMBLER 800 Workshop Manual

Engine stop button

Using a multimeter, check for continuity between the Red/White and Red/Black wires:
- when button (3) is in RUN position (A), there should be electrical continuity between the two wires;
- when the button is in the OFF position (B), there should be no electrical continuity between the two wires.
If these conditions are not met, the engine stop switch is not working correctly and must be replaced.

Starter button

Proceed as described for the engine stop button and check for continuity between the Blue/White and Black
wires when the starter button (2) is pressed.
If there is no continuity, the starter button is faulty and must be replaced.
Colours mentioned in the descriptions refer to the colour of wires from the switch and not to the colour of
the main electric system wires.
For the refitting procedure refer to chapter "Refitting the
handlebar".

Rear stop switch

The rear STOP switch (1) is located inside the RH footpeg holder plate.

REAR STOP SWITCH CONTROL