Table of Contents
Advertisement
If the backlash is still outside the tolerance limits, replace the complete primary drive gear (1).
After having checked the backlash, lock gear (8) using reaction tool no. 88713.2423, apply the specified
grease on ring nut (7), and tighten it to a torque of 190 Nm (Min. 171 Nm - Max. 209 Nm).
Bend the washer (6) over ring nut (7).
Refit the oil pump and check the backlash between the oil pump gear and the primary drive gear on the
crankshaft.
Thoroughly degrease the mating surfaces of the clutch housing (1) of internal bearing (3).
Insert inner spacer (4) inside primary shaft, with the flat side facing outside.
Fit the inner ring (5), the clutch housing (1) along with the driven gear (8) with needle bearing (3).
Advertisement
Table of Contents
