Right-Hand Switch; Right-Hand Switch Control - Ducati SCRAMBLER 800 Workshop Manual

Hide thumbs Also See for SCRAMBLER 800:

Table of Contents

Buttons used to display and set instrument panel parameters.

Connect the multimeter to the Red and Black wires arriving from the instrument panel function selector

switch and check for electrical continuity when pressing button (5).

Repeat the same procedure, press button (4) and connect the multimeter to the Red/Black and Blue/Yellow

Low beam and high beam (Hi Beam) (6)

Test using the same procedure, applying the probes of the meter to the Red and Blue wires and moving

switch down.

Flash switch (PASSING) (6)

The high-beam flash button may also be used for LAP functions.

Check for continuity between the Red and Orange wires.

Unlike the Hi Beam, switch (6) should be pressed.

For the refitting procedure refer to chapter

"Refitting the

Right-hand switch

In the event of a fault, the internal connections of the device must be checked in all operating conditions. It

is therefore necessary to disconnect the main wiring switch connector and perform the check using an

analogue or digital multimeter.

The same test may be done using the "DDS 2" diagnosis instrument.

Remove the RH handgrip as described in chapter

"Removing the

Loosen screws (1) and remove the right-hand switch by disconnecting it from the main connection. The

colours mentioned in the following descriptions refer to the colour of the wires from the switch and not to

the colour of the main electric system wires.