Table of Contents
Advertisement
Siphon the fluid from the reservoir (6). Fill the reservoir (7) with new oil up to the MAX mark.
Attention
During the filling operation, always keep the fluid level above the MIN mark to avoid any air bubbles in the
circuit.
Allow the fluid to flow from the bleeder (8) until it changes colour. Press the pedal two or three times until
the circuit is pressurised. Hold pedal depressed.
Open the bleed valve (8) to allow fluid to flow out.
The pedal is at the end of travel when it is in the lower position. Now, screw bleed valve (8) to a torque of
10 Nm ±10%, and release the pedal; press the pedal again.
Repeat the above operation until the old fluid flows out completely.
Warning
After draining the old fluid from the reservoir and while filling the system, always keep the fluid level above
the MIN mark to avoid any air bubbles in the circuit.
Advertisement
Table of Contents
