Instrument Panel - Ducati SCRAMBLER 800 Workshop Manual

Instrument panel

1) LCD.
2) REV COUNTER (rpm).
It indicates engine rpm value.
3) NEUTRAL LIGHT N (GREEN).
Comes on when in neutral position.
4) HIGH BEAM LIGHT
(BLUE).
It turns on to indicate that the high beam lights are on and when the flasher is activated.
5) ENGINE OIL PRESSURE LIGHT
(RED).
Comes on when engine oil pressure is too low. It must turn on at "KEY-ON", but must turn OFF a few
seconds after the engine has started. It may shortly come on when the engine is hot, however, it should go
out as the engine revs up.
Important
If the ENGINE OIL light stays ON, stop the engine or it may suffer severe damage.
6) FUEL WARNING LIGHT
(AMBER YELLOW).
Comes on when fuel is low and there are about 4 litres (1.06 gallons) of fuel left in the tank.
7) TURN INDICATOR LIGHTS
(GREEN).
A warning light turns on and blinks when the relevant turn indicator is active; when the warning lights blink
at the same time, the HAZARD function is active.
8) "ENGINE/VEHICLE DIAGNOSIS - EOBD" LIGHT
(AMBER YELLOW).
It turns on in the case of "engine" and/or "vehicle" errors and in some cases will lock the engine.
9) ABS LIGHTS
(AMBER YELLOW).
This turns on to indicate that ABS is disabled or not functioning.
Engine OFF / speed below 5 km/h (3 mph)
Light OFF
-
Engine ON / speed below 5 km/h (3 mph)
Light OFF
-
Engine ON / speed above 5 km/h (3 mph)
Light OFF
ABS enabled and
functioning
10) OVER REV / IMMOBILIZER / ANTI-THEFT SYSTEM (RED)
Light flashing
ABS disabled with the menu function
"ABS"
Light flashing
ABS disabled with the menu function
"ABS"
Light flashing
ABS disabled with the menu function
"ABS"
Light steady on
ABS enabled, but not functioning yet
Light steady on
ABS enabled, but not functioning yet
Light steady on
ABS disabled and not functioning due to a
problem