Removal Of The Lamp Module - Barco DP2K-E series User And Installation Manual

13.2 Removal of the Lamp Module

W
ARNING
for at least 15 minutes before attempting to access or handle the Lamp Module.
W
ARNING
personnel.
C
AUTION
Necessary tools
7mm nut driver or flat screw driver.
How to remove the Lamp Module from the projector?
1. Ensure the projector is switched off and cooled down.
2. Remove the rear cover of the projector. See "Removal of the rear cover", page 121.
3. Loosen the retaining screw (1) of the fan door and open the door (2).
Image 13-2
4. Release the three retaining screws (3) of the Lamp Module. Use a 7mm nut driver or a flat screw driver.
R5906693 DP2K-E SERIES 19/06/2015
:
The Lamp Module is extremely hot during and directly after operation. Let the projector cool down
:
This procedure may only be carried out by trained projectionists or qualified technical service
:
Due to its high internal pressure, the lamp may explode in hot state if improperly handled.
1
2
13. Lamp House
101