Check The Dust Filters - Barco DP2K-E series User And Installation Manual

15. Maintenance procedures
15.1 Check the dust filters
Necessary tools
7mm flat screwdriver.
How to check the dust filters?
1. Remove the front cover. See "Removal of the front cover", page 120.
2. Take out the big (1) & small (2) dust filter assembly from the projector.
3. Check the "air in" side of the dust filters for dust and/or grease.
In case the filter is contaminated with grease wash and dry the dust filter. See cleaning procedure "Washing and drying the dust
filters", page 114.
In case the filter contains dust but doesn't feel greasy then vacuum clean the dust filter. See procedure "Vacuum cleaning of the
dust filters", page 113.
Note: Grease on the filter can build up after several months in an environment contaminated with greasy air. Note that areas
where popcorn is consumed are subject to greasy air.
Tip: Take into account that the time needed to dry the dust filters may be 24 hours or more. For that, it's recommended to
have a second set of dust filters which can be used while cleaning the first set.
4. Insert the big (1) & small (2) dust filter assembly in the front cover.
Caution: UNDER NO CIRCUMSTANCES SHOULD WET FILTERS BE INSTALLED BACK INTO THE PROJECTOR. THIS
CAN HAVE SERIOUS SAFETY CONSEQUENCES AS WELL AS JEOPARDIZE THE INTERNAL OPTICS OF THE
SYSTEM.
Image 15-1
5. Install the front cover. See "Removal of the front cover", page 120.
The dust filter is cleanable. See cleaning procedure for correct cleaning and drying instructions.
112
1
2
R5906693 DP2K-E SERIES 19/06/2015