Connecting A Ups To The Projector Electronics - Barco DP2K-E series User And Installation Manual

5. Physical installation
5.3

Connecting a UPS to the projector electronics

W
ARNING
requirements" for more information about the requirements of the UPS.
Necessary tools
3mm Allen wrench
How to connect the UPS
1. Remove the right side cover of the projector. See procedure "Removal of the right side cover", page 125.
2. Remove the rear cover. See "Removal of the rear cover", page 121.
3. Remove the 2 screws (1) of the SMPS cover (2) and remove the cover. Use a 3mm Allen wrench.
Image 5-6
4. Plug out the connector which is plugged into the AC socket (3). Plug the connector in the UPS socket (4).
Image 5-7
5. Install the SMPS cover and install the 2 screws. Use a 3mm Allen wrench.
6. Install the rear cover. See "Installation of the rear cover", page 134.
7. Install the UPS according to the instructions of the manufacturer and the local regulations.
8. Connect the power output cord from the UPS unit to the UPS inlet socket (5) of the projector.
28
:
Only use UPS units which are suitable for the DP2K-E series projector. See chapter "Installation
2
3
1
1
R5906693 DP2K-E SERIES 19/06/2015
4