7. Input & Communication
7.1
Introduction
General
The Input & Communication side of the DP2K-E series projector consists of a Local Keypad integrated into the projector housing
and a card cage with three slots. The top side of the projector is equipped with a tail light which reflects the status of the projector.
The projector card cage is equipped with an ICMP. See illustration below. Note that all information about the ICMP is gathered into
one separated chapter: "ICMP", page 47.
1
2
Image 7-1
1
Projector status light.
2
Power ON/OFF switch.
3
Local keypad.
4
Barco Cinema Controller.
5
ICMP.
C
AUTION
the boards (except for the Cinema Controller) will result in an authorization request upon starting.
40
3
5
4
:
A unit may only be removed from the card cage by qualified service personnel. Removing one of
R5906693 DP2K-E SERIES 19/06/2015