Installation Of The Top Cover Plate Of The Light Processor Compartment - Barco DP2K-E series User And Installation Manual

16.9 Installation of the top cover plate of the Light Processor compartment

Necessary tools
3 mm Allen key
How to install the top cover plate from the Light Processor compartment?
1. Install the top cover plate as follows:
a) Position yourself on the right side of the projector, and place the cover on an angle as shown.
b) Lower the top cover plate completely.
c) Slide the top cover plate towards the back of the projector until all slots of the top cover plate are properly engaged (reference
image 16-11).
Image 16-11
2. Install the seven screws (reference 1, image 16-12). Use a 3 mm Allen Key.
Image 16-12
C
AUTION
result in a tamper event. An authorization to clear the security warning on the projector, after closing off the
Light Processor compartment, will be needed!
R5906693 DP2K-E SERIES 19/06/2015
C
1
:
Opening the Light Processor compartment by removing the top cover plate or side cover plate will
16. Removal and installation of the projector covers
A
B
129