Removal And Installation Of The Projector Covers - Barco DP2K-E series User And Installation Manual

16. REMOVAL AND INSTALLATION OF THE PROJECTOR
COVERS
About this chapter
Most installation, maintenance and service procedures demand removing one or more of the projector covers to gain access to the
parts to maintain or to service. To avoid redundancy, all procedures about cover removing or installing are grouped together in this
chapter. The maintenance and servicing procedures also refer to this chapter if required. The procedures in this chapter describe,
with detailed step by step actions and illustrations, how to remove or install the projector covers. Note that the covers may only be
removed by qualified service personnel.
W
ARNING
or qualified SERVICE PERSONNEL.
W
ARNING
unless otherwise stated.
Overview
• Removal of the front cover
• Removal of the rear cover
• Removal of the top cover
• Removal of the left side cover
• Removal of the right side cover
• Removal of the top cover plate of the Light Processor compartment
• Removal of the side cover plate of the Light Processor compartment
• Installation of the side cover plate of the Light Processor compartment
• Installation of the top cover plate of the Light Processor compartment
• Installation of the right side cover
• Installation of the left side cover
• Installation of the top cover
• Installation of the rear cover
• Installation of the front cover
R5906693 DP2K-E SERIES 19/06/2015
:
All procedures described in this chapter may only be performed by TRAINED PROJECTIONISTS
:
Always switch off the projector and unplug the power cord before removing one of the covers,

16. Removal and installation of the projector covers

119