12.4 Converging the green pattern onto the red pattern
This adjustment procedure assumes that the projector is prepared for convergence adjustment.
Necessary tools
No tools.
How to converge the green pattern onto the red pattern?
1. Slightly turn the green colored control knob number 4 until the green pattern in the center of the projected image converges with
the red pattern. Note that a turn of a few degrees corresponds with one full pixel. The direction on the control knob corresponds
to the direction of the arrow of the test pattern.
Image 12-8
2. Slightly turn the green colored control knob number 5 until the green pattern in the lower left of the projected image converges
with the red pattern.
Image 12-9
3. Slightly turn the green colored control knob number 6 until the green pattern in the upper right of the projected image converges
with the red pattern.
Image 12-10
4. Repeat step 2 and 3 until coincidence is obtained of the green pattern in the lower left and upper right of the projected image.
5. Repeat from step 1 until full coincidence is obtained of the green pattern in the center, lower left and upper right of the
projected image.
6. Switch off the projector.
7. Continue with the procedure Closing off the Light Processor compartment.
R5906693 DP2K-E SERIES 19/06/2015
4
2
5
3
6
12. Convergence
97