13.3 Installation of the Lamp House
W
ARNING
Necessary tools
7mm nut driver or flat screw driver.
How to install the Lamp House in the projector?
1. Insert the Lamp House as follows:
a) Grip the Lamp House by the handle (4) and support it at the bottom with the other hand. Slide the Lamp House in the lamp
compartment.
b) Carefully insert the Lamp House into the projector. Make sure the positioning pins (reference 5, image 13-1) match the holes
in the projector.
Image 13-5
2. Tighten the three retaining screws (3) of the Lamp House. Use a 7mm nut driver or a flat screw driver.
Image 13-6
3. Close the fan door (2) and tighten the retaining screw (1) of the fan door.
R5906693 DP2K-E SERIES 19/06/2015
:
This procedure may only be performed by qualified technical service personnel.
3
3
4
3
3
3
3
13. Lamp House
103