Barco DP2K-E series User And Installation Manual page 77

Image 9-6
4. Connect the DC plug, the RJ45 Ethernet plug and the D-SUB plug of the customized cable into their respective sockets on the
Touch Panel interface.
Image 9-7
5. Remove the right side cover. See "Removal of the right side cover", page 125.
6. Connect the circular plug of the customized cable with the circular socket (6) at the right side of the Local Keypad of the projector.
Caution: To avoid connector damage, align the pins before you connect the customized cable.
Note: Ensure to tighten the locking nut on the connector.
Image 9-8
7. Attach the multi cable to the swivel arm using the two Velcro strips.
8. Position the Touch Panel interface in the desired location. See "Repositioning the Touch Panel interface", page 74.
R5906693 DP2K-E SERIES 19/06/2015
5
6
9. Communicator Touch Panel
73