Motorola AP-7131N-FGR Product Reference Manual page 623

NOTE It is possible to have different ESSID and WLAN assignments within a
single mesh network (one set between the Base Bridge and repeater and
another between the repeater and Client Bridge). However, for ease of
management and to not waste network bandwidth, Motorola
recommends using the same ESSID across the entire mesh network.
4. Use the Available On
target WLAN within the mesh network.
The Available On checkboxes are for making this WLAN available for base bridges or
repeaters to connect to. The Available On checkbox should only be selected for a mesh
WLAN if this target access point is to be configured as a base bridge or repeater on the
radio. If the WLAN is to be defined for client bridge support only, the Available On
checkbox should not be selected. Instead, it only needs to have the Enable Client Bridge
Backhaul option selected.
5. Use the Maximum MUs
this WLAN. This number should be defined based on the number of client bridge and
repeaters within this mesh network. This value can be increased as the mesh network
grows and devices are added.
Only advanced users should define the number of devices allowed to associate with the
WLAN, as setting the value too low could restrict devices from joining an expanding
mesh network, and setting it too high could prohibit other WLANs from granting access
to the all the devices needed.
6. Select the Enable Client Bridge Backhaul
the Mesh Network Name
Only WLANs defined for mesh networking support should have this checkbox selected,
in order to keep the list of WLANs available (within the Radio Configuration screen)
restricted to just WLANs configured specifically with mesh attributes.
7. Refer to the Security Policy
this WLAN and mesh network.
A security policy for a mesh network should be configured carefully since the data
protection requirements within a mesh network differ somewhat compared to a typical
wireless LAN. Motorola discourages user-based authentication schemes such as
802.1x EAP, as this authentication scheme is not supported within a mesh network.
If none of the existing policies are suitable, select the
Security Policy
network. For information on configuring a security using the authentication and
checkboxes to specify the access point radio(s) used with the
field to define the number of MUs allowed to associate with
drop-down menu within the
drop-down menu to select the security policy used within
drop-down menu and configure a policy suitable for the mesh
Configuring Mesh Networking
checkbox to make this WLAN available in
Radio Configuration
Create button to the right of the
9-11
screen.