Motorola AP-7131N-FGR Product Reference Manual page 183

Enable Client Bridge
Backhaul
Enable Hotspot
CAUTION A WLAN cannot be enabled for both mesh and hotspot support at the
!
4. Configure the Security
WLAN.
Security Policy
MU Access Control
5. Configure the Advanced
beacon transmissions, broadcast ESSID acceptance and Quality of Service (QoS) policies.
Select the Enable Client Bridge Backhaul
WLAN available in the
Configuration screen. This checkbox can be ignored for WLANs
not supporting mesh networking, to purposely exclude them from
the list of WLANs available in the Radio Configuration page
selected specifically for mesh networking support. Only WLANs
defined for mesh networking support should have this checkbox
selected.
Select the Enable Hotspot
it be a new or existing WLAN) to be configured for hotspot support.
Clicking the Configure Hotspot
the parameters of the hotspot can be defined. For information on
configuring a target WLAN for hotspot support, see
WLAN Hotspot Support on page
hotspot is and what it can provide your wireless network, see
Hotspot Support on page
same time. Only one of these two options can be enabled at one time,
as the GUI and CLI will prevent both from being enabled.
field as required to set the data protection requirements for the
Use the scroll down
scheme best suited for the new or revised WLAN. Click the
button to launch the New Security Policy screen where a new
policy can be created to suit the needs of the WLAN. For more
information, see Configuring WLAN Security Policies on page 5-37
Select an ACL policy suiting the WLAN's MU introperability
requirements from the drop-down menu. If the existing ACL
policies do not satisfy the requirements of the WLAN, a new ACL
policy can be created by pressing the
information, see Configuring a WLAN Access Control List (ACL) on
page 5-38.
field as required to set MU interoperability permissions, secure
WLAN drop-down menu within the
checkbox to allow this WLAN (whether
button launches a screen wherein
5-48. For an overview of what a
1-20.
Security Policies menu to select the security
Create
Network Management
checkbox to make the
Radio
Configuring
Create
.
button. For more
5-35