Motorola AP-7131N-FGR Product Reference Manual page 204

5-56 AP-7131N-FGR Access Point Product Reference Guide
Refer to
radio. After the settings are applied within this Radio Configuration screen, the
Status
network, these values update in real-time.
NOTE This section describes mesh networking (setting the radio's base and
2. Set the
The maximum number of MUs that can associate to an AP-7131N-FGR is 127. Therefore, the
possible number of MUs that can associate to each radio must be negotiated between 0 and
127.
NOTE The AP does not support MU radio associations if its Maximum MUs value
3. Select the
from other access points in client bridge mode. The base bridge is the acceptor of mesh
network data from those client bridges within the mesh network and never the initiator.
4. If the Base Bridge checkbox has been selected, use the
to define the client bridge load on a particular base bridge.
The maximum number of client bridge connections per radio is 12, with 24 representing the
maximum for dual-radio models.
CAUTION An access point is Base Bridge mode logs out whenever a Client
!
Once the settings within the Radio Configuration screen are applied (for an initial
deployment), the current number of client bridge connections for this specific radio displays
RF Band of Operation
and MUs connected
client bridge configuration) at a high level. For a detailed overview on the
theory of mesh networking, see
For detailed information on the implications of setting the mesh
configuration, see
review mesh network deployment scenarios, see
Deployment - Quick Setup on page
Maximum MUs between 0 - 127.
is set to 0. Alternatively, if you set the value to 127 for one radio, you risk
shutting out MU associations for the other radio, as the AP does not
validate the logic of a user's MU association distribution.
Base Bridge checkbox to allow the radio to accept client bridge connections
Bridge associates to the Base Bridge over the LAN connection. This
problem is not experienced over the access point's WAN connection. If
this situation is experienced, log-in to the access point again.
parameter to ensure you are enabling the correct
values update. If this is an existing radio within a mesh
Mesh Networking Overview on page
Configuring Mesh Networking Support on page
9-20.
Mesh Network
Max# Client Bridges
Radio
9-1.
9-6. To
parameter