Motorola AP-7131N-FGR Product Reference Manual page 123

OID
Passwords
Access
4. Specify the users who can read and optionally modify the SNMP-capable client.
SNMP Access Control Click the
5. If configuring SNMP v3 user definitions, set the SNMP v3 engine ID.
SNMP v3 Engine ID
Use the OID (Object Identifier) area to specify a setting of All or
enter a Custom OID. Select
in the MIB. The OID field uses numbers expressed in dot notation.
Select Passwords to display the
specifying authentication and password settings for an SNMP v3
user. The maximum password length is 11 characters. Use the
Authentication Algorithm
SHA1 as the authentication algorithm. Use the Privacy Algorithm
drop-down menu to define an algorithm of
When entering the same username on the
SNMP Access screens, the password entered on the SNMP Traps
page overwrites the password entered on the SNMP Access page.
To avoid this problem, enter the same password on both pages.
Use the Access pull-down list to specify read-only (R) access or
read/write (RW) access for a user. Read-only access permits a user
access point
to retrieve
allows a user to modify
SNMP Access Control
Access Control screen for specifying which users can read
SNMP-generated information and potentially modify related
settings from an SNMP-capable client.
The SNMP Access Control screen's Access Control List (ACL) uses
Internet Protocol (IP) addresses to restrict access to the AP's SNMP
interface. The ACL applies to both SNMP v3 user definitions and
SNMP v1/v2c community definitions.
For detailed instructions of configuring SNMP user access and
modification privileges, see
page 4-35.
The access point SNMP v3 Engine ID
v3 Engine ID for the access point. This ID is used in SNMP v3 as the
source for a trap, response or report. It is also used as the
destination ID when sending get, getnext, getbulk, set or inform
commands.
All to assign the user access to all OIDs
Password Settings
drop-down menu to specify
DES
SNMP Traps
information, while read/write access
access point
settings.
button to display the
Configuring SNMP Access Control on
field lists the unique SNMP
System Configuration
screen for
MD5 or
or AES-128bit.
and
SNMP
4-33