Motorola AP-7131N-FGR Product Reference Manual page 431

AP7131N>admin(network.wireless.radio)> set
Description:
Sets the access point's radio configuration and defines the RF band of operation.
Syntax:
set radio-config
max-mus
mesh-base
mesh-max
mesh-client
mesh-roaming-client
mesh-timeout
mesh-wlan
dot11-auth
qos-mapping
(wired-to-wireless)
Example:
admin(network.wireless.radio)>set max-mus 127
admin(network.wireless.radio)>set mesh-base 1 enable
admin(network.wireless.radio)>set mesh-max 1 11
admin(network.wireless.radio)>set mesh-client 1 disable
admin(network.wireless.radio)>set mesh-roaming-client 1 enable
admin(network.wireless.radio)>set mesh-wlan wlan1
admin(network.wireless.radio)>set dot11-auth shared-key-allowed
<mode> Sets the radio configuration.
<mus>> Defines the maximum number of MUs assigned to the specified radio (idx 1 or 2).
The range can be defined between 0 and 127. This command does not apply to
single radio access points.
<mode> Enables or disables base bridge mode.
<clients> Sets the maximum number of wireless bridge clients.
<mode> Enables or Disables client bridge mode.
<mode> Enables or disables the mesh roaming client mode. For information on the Mesh
Roaming Client feature, see
<mode> Sets the client bridge link timeout.
<name> Defines the client bridge WLAN name.
<auth-algorithm> Defines dot11 level authentication algorithm to either
shared-key-allowed.
<mode> Sets the QoS mapping from wired to wireless.
Mesh Roaming Client on page
open-system-only
8-93
1-8.
or