Configuring The Access Point - Motorola AP-7131N-FGR Product Reference Manual

3-6 AP-7131N-FGR Access Point Product Reference Guide
A Security Error: Domain Name Mismatch
At this point in the browser configuration, a screen displays stating the Web site's certificate
cannot be verified.
6. Click Yes
7. Log in using
default login is successful, the
recommended you immediately change the password to optimize device security. For more
information, see

3.4.2 Configuring the Access Point

For the basic setup described in this guide, the Java-based Web UI will be used to configure the
access point. The GE1/POE port's default setting is static (with a default IP address of 192.168.0.1).
For this example, the access point's WAN interface will be used to connect to the access point. The
default WAN IP address is 10.1.1.1. For optimal viewing of the Web UI, the screen resolution should
be set to 1024 x 768 pixels or greater.
Remember, Internet Explorer and Mozilla Firefox require unique settings be defined in order for the
browser to access the AP-7131N-FGR GUI applet. For instructions on configuring these browser
settings, see Configuring Your Browser for AP-7131N-FGR Support on page
1. Start a browser and enter the following IP address in the address field:
https://10.1.1.1
2. Log in using
your new password if it has been updated from default.
NOTE For optimum compatibility, use Sun Microsystems' JRE 1.6 or higher
to continue. The access point's login screen displays.
admin as the default User ID and
Change Admin Password
Configuring the Access Point on page
admin as the default Username and
(available from Sun's Website), and be sure to disable Microsoft's Java
Virtual Machine if installed.
screen could display. Click
motorola as the default password. If the
window displays. It is strongly
3-6.
3-4.
motorola as the default Password. Use
OK to continue.