Motorola AP-7131N-FGR Product Reference Manual page 159

NOTE Motorola recommends the WAN and LAN ports should not both be
configured as DHCP clients.
This interface is a
DHCP Client
This interface is a
BOOTP Client
This interface uses
static IP Address
This interface is a
DHCP Server
Address Assignment
Range
Select this button to enable DHCP to set network address
information via this LAN1 or LAN2 connection. This is
recommended if the access point resides within a large corporate
network or the Internet Service Provider (ISP) uses DHCP. This
setting is enabled for LAN1 by default.
DHCP is a protocol that includes mechanisms for IP address
allocation and delivery of host-specific configuration parameters
from a DHCP server to a host. If DHCP Client is selected, the first
DHCP or BOOTP server to respond sets the IP address and network
address values since DHCP and BOOTP are interoperable.
Select this button to enable BOOTP to set access point network
address information via this LAN1 or LAN2 connection.
When selected, only BOOTP responses are accepted by the access
point. If both DHCP and BOOTP services are required, do not select
BOOTP Client.
Select the This interface uses static IP Address
manually enter static network address information in the areas
provided.
The access point can be configured to function as a DHCP server
over the LAN1 or LAN2 connection. Select the
DHCP Server button and manually enter static network address
information in the areas provided.
Use the address assignment parameter to specify a range of
numerical (non DNS name) IP addresses reserved for mapping
client MAC addresses to IP addresses. If a manually (static)
mapped IP address is within the IP address range specified, that IP
address could still be assigned to another client. To avoid this,
ensure all statically mapped IP addresses are outside of the IP
address range assigned to the DHCP server.
Network Management
button, and
This interface is a
5-11