Programmable Snmp V1/V2/V3 Trap Support; Power-Over-Ethernet Support - Motorola AP-7131N-FGR Product Reference Manual

1.2.15 Programmable SNMP v1/v2/v3 Trap Support

Simple Network Management Protocol (SNMP) facilitates the exchange of management information
between network devices. SNMP uses Management Information Bases (MIBs) to manage the device
configuration and monitor Internet devices in remote locations. MIB information accessed via SNMP
is defined by a set of managed objects called Object Identifiers (OIDs). An OID is used to uniquely
identify each object variable of a MIB.
SNMP allows a network administrator to configure the access point, manage network performance,
find and solve network problems, and plan network growth. The access point supports SNMP
management functions for gathering information from its network components. The access point's
download site contains the following MIB files supporting the access point:
• Symbol-CC-WS2000-MIB-2.0 (standard MIB file)
• Symbol-AP_MIB
The access point's SNMP agent functions as a command responder and is a multilingual agent
responding to SNMPv1, v2c and v3 managers (command generators). The factory default
configuration maintains SNMPv1/2c support of community names, thus providing backward
compatibility.
For detailed information on configuring SNMP traps, see

1.2.16 Power-over-Ethernet Support

When users purchase a Motorola WLAN solution, they often need to place access points in obscure
locations. In the past, a dedicated power source was required for each access point in addition to the
Ethernet infrastructure. This often required an electrical contractor to install power drops at each
access point location.
An approved Power Injector solution merges power and Ethernet into one cable, reducing the burden
of installation and allows optimal access point placement in respect to the intended radio coverage
area. The access point can only use a Power-over-Ethernet device when connected to the access
point's LAN (GE1/POE) port. The access point can also support 3af/3at compliant products from other
vendors.
The Power Injector (Part No. AP-PSBIAS-1P3-AFR) is a single-port Power over Ethernet hub combining
low-voltage DC with Ethernet data in a single cable connecting to the access point. The Power
Injector's single DC and Ethernet data cable creates a modified Ethernet cabling environment on the
access point's LAN port eliminating the need for separate Ethernet and power cables. For detailed
information on using the Power Injector, see
Configuring SNMP Settings on page
Power Injector System on page
Introduction
4-28.
2-7.
1-15