Motorola AP-7131N-FGR Product Reference Manual page 379

AP7131N>admin(network.wan)> set
Description:
Defines the configuration of the access point WAN port.
Syntax:
set wan enable/disable
dhcp enable/disable
ipadr <idx>
mask <a.b.c.d>
dgw <a.b.c.d>
dns <idx>
auto- enable/disable
negotiation
speed <mbps>
duplex <mode>
pppoe mode
user
passwd
ka
idle
type
Example:
admin(network.wan)>
admin(network.wan)>set dhcp disable
admin(network.wan)>set ipadr 157.169.22.5
admin(network.wan)>set dgw 157.169.22.1
admin(network.wan)>set dns 1 157.169.22.2
admin(network.wan)>set auto-negotiation disable
admin(network.wan)>set speed 10M
admin(network.wan)>set duplex half
admin(network.wan)>set mask 255.255.255.000
admin(network.wan)>set pppoe mode enable
admin(network.wan)>set pppoe type chap
admin(network.wan)>set pppoe user jk
admin(network.wan)>set pppoe passwd @#$goodpassword%$#
admin(network.wan)>set pppoe ka enable
admin(network.wan)>set pppoe idle 600
For an overview of the WAN configuration options available using the applet (GUI), see
Enables or disables the access point WAN port.
Enables or disables WAN DHCP Client mode.
<a.b.c.d> Sets up to 8 (using <indx> from
access point WAN interface.
Sets the subnet mask for the access point WAN interface.
Sets the default gateway IP address to <a.b.c.d>.
<a.b.c.d> Sets the IP address of one or two DNS servers, where <indx>
indicates either the primary (1) or secondary (2) server, and <a.b.c.d>
is the IP address of the server.
Enables or disables auto-negotiation for the access point WAN port.
Defines the access point WAN port speed as either 10 Mbps or 100
Mbps.
Defines the access port WAN port duplex as either half or full.
enable/disable Enables or disables PPPoE.
<name> Sets PPPoE user name.
<password> Defines the PPPoE password.
enable/disable Enables or disables PPPoE keepalive.
<time> Sets PPPoE idle time.
<auth-type> Sets PPPoE authentication type.
1 to 8) IP addresses <a.b.c.d> for the
Configuring WAN Settings on page
8-41
5-17.