Installing The Drive Shaft - SELVA MARINE Blue Whale 250 EFI Service Manual

Needle bearing attachment 1:
90890-06610
Driver rod SS 2: 90890-06604
Depth a:
4.5 ± 0.25 mm (0.18 ± 0.01 in)
2. Apply grease to the new oil seals, and
then install them into the drive shaft
housing to the specified depth.
4
3
NOTE:
Install an oil seal halfway into the drive shaft
housing, then the other oil seal.
Bearing outer race attachment 3:
90890-06628
Driver rod LS 4: 90890-06606
Depth b:
0.5 ± 0.25 mm (0.02 ± 0.01 in)

Installing the drive shaft

1. Install the thrust bearing and reverse
gear into the lower case.
6P23H11
Drive shaft and lower case (counter rotation model)
2. Install the washer, spring and thrust
bearing into the lower case.
b
3. Install the drive shaft housing 1, thrust
bearing 2, and original shim(s) 3 onto
the drive shaft 4.
S6P26120E
NOTE:
• Be sure to select the pinion shim(s) if
replacing the thrust bearing, drive shaft
housing, drive shaft or lower case.
• To select the shims, see "Shimming
(counter rotation model)."
1
2
3
4
5
6
7
8
9
6-48