Assembling The Upper Case - SELVA MARINE Blue Whale 250 EFI Service Manual

Oil pan bolt 6:
20 N·m (2.0 kgf·m, 14.8 ft·lb)
Exhaust manifold bolt 8:
20 N·m (2.0 kgf·m, 14.8 ft·lb)
6. Install the new gasket and plate 9.
7. Install the rubber seal and cooling water
pipe 0 into the muffler A.
8. Install the new gasket, muffler A and
bolts onto the oil pan, and then tighten
the bolts to the specified torque.
NOTE:
Install the cooling water pipe positioned as
shown.
Muffler bolt:
20 N·m (2.0 kgf·m, 14.8 ft·lb)

Assembling the upper case

1. Install the drive shaft bushing into the
upper case, and then install the circlip.
6P23H11
Upper case and steering arm
1
WR-No.2
NOTE:
After installing the drive shaft bushing, apply
grease to the inside of the bushing.
Needle bearing attachment 1:
90890-06653
Driver rod L3 2: 90890-06652
1
2
2
S6P27850E
3
4
5
6
7
8
9
7-12