Propeller Shaft Housing (Counter Rotation Model); Removing The Propeller Shaft Housing Assembly; Disassembling The Propeller Shaft Housing - SELVA MARINE Blue Whale 250 EFI Service Manual

Removing the propeller shaft
housing assembly
1. Remove the water pipe 1 and shift rod
2.
2. Remove the bolts 3, ring 4, and bolts
5.
3. Pull out the propeller shaft housing with
the propeller shaft.
NOTE:
Before removing the propeller shaft from the
lower case, remove the shift rod.
Slide hammer 6: 90890-06531
Puller head 7: 90890-06514
6P23H11

Propeller shaft housing (counter rotation model)

Disassembling the propeller shaft
housing
1. Remove the spring 1, and then remove
the cross pin 2, dog clutch 3, slider,
shift plunger, and shift rod joint.
2
2. Remove the forward gear and forward
gear shim(s) from the propeller shaft
housing using a press.
Bearing separator 4: 90890-06534
3. Remove the dowel from the lower case.
4. Install the propeller shaft housing assem-
bly in the reverse direction into the lower
case.
1
3
S69J6375
6-38
1
2
3
4
5
6
7
8
9