Installing The Ptt Motor - SELVA MARINE Blue Whale 250 EFI Service Manual

BRKT
2. Fill the trim cylinders with the recom-
mended fluid to the correct level b as
shown.
3. Install the trim ram assembly into the trim
cylinder, and then tighten the trim cylin-
der end screws 2 to the specified
torque.
2
WARNING
Do not push the trim rams down while
installing them into the trim cylinders.
Otherwise, the PTT fluid may spurt out
from the unit.
Cylinder-end screw wrench:
90890-06568
Trim cylinder end screw 2:
160 N·m (16.0 kgf·m, 118.0 ft·lb)

Installing the PTT motor

1. Install the joint 1 into the gear pump.
7-43
Bracket unit
2
S6S17130
2. Fill the pump housing with the recom-
mended fluid to the correct level a as
shown.
3. Remove all of the air bubbles with a
syringe or suitable tool.
NOTE:
Turn the joint 1 with a screwdriver, and then
remove any air between the pump gear teeth.
4. Install the new O-ring 2 and PTT motor
3, and then tighten the bolts 4 to the
specified torque.
6P23H11