Removing The Wiring Harness Guide - SELVA MARINE Blue Whale 250 EFI Service Manual

Timing belt-to-timing belt guide
clearance t:
1.0 ± 0.5 mm (0.04 ± 0.02 in)
29. Install the wiring harness guide.
NOTE:
To install the wiring harness guide, see
"Installing the wiring harness."
30. Install all parts removed during disas-
sembly.
31. Check that the wiring harness, hoses,
and other parts do not interfere with any
moving parts.

Removing the wiring harness guide

NOTE:
This procedure is for adjusting the valve
clearance and replacing the timing belt.
1. Remove the joint connector 1 from the
wiring harness guide.
1
2. Disconnect the oil control valve couplers
2, engine temperature sensor coupler
3, and thermoswitch connectors 4.
3. Remove the engine temperature sensor
coupler 3 and low-pressure fuel pump
coupler 5 from the wiring harness guide.
4. Remove the 3-pin communication cou-
pler 6 and diagnosis connector 7 from
the bracket.
6P23H11
5
5. Remove the port and starboard fuel rail
covers and plastic ties.
NOTE:
See the exploded diagram (4-26).
6. Disconnect all fuel injector couplers.
S6P25380
PORT
4
6
7
STBD
2
Power unit
3
1
2
2
S6P25390
4
3
4
S6P25400
5
6
7
8
9
5-20