SELVA MARINE Blue Whale 250 EFI Service Manual page 132

POWR
23. Turn the crankshaft clockwise two full
turns, and then check that alignment
marks c through f are aligned.
d
f
e
24. Install the stator assembly.
25. Install the Woodruff key.
26. Install the flywheel magnet.
NOTE:
• Apply engine oil to the thread of the fly-
wheel magnet nut and washer before
installation.
• Be sure to remove any grease from the
tapered portion of the crankshaft and fly-
wheel magnet.
Flywheel holder: 90890-06522
5-19
Power unit
c
S6P25180
Flywheel magnet nut:
240 N·m (24.0 kgf·m, 177.0 ft·lb)
27. Check the crank position sensor air gap
s.
s
NOTE:
It is recommended to check the crank posi-
tion sensor air gap before installing the wiring
harness guide to improve working efficiency.
Crank position sensor air gap s:
1.4–1.6 mm (0.055–0.063 in)
Crank position sensor screw:
4 N·m (0.4 kgf·m, 3.0 ft·lb)
28. Install the timing belt guide, and then
adjust the timing belt-to-timing belt guide
clearance t.
t
S6P25270
t
S6P25280
6P23H11