SELVA MARINE Blue Whale 250 EFI Service Manual page 188

POWR
7. Connect the cooling water pilot hose C.
8. Connect the neutral switch coupler D
and shift cut switch coupler E, and then
install them onto the bracket.
9. Install the dipstick guide F and oil dip-
stick G.
G
E
NOTE:
Apply engine oil to the O-ring before installing
the dipstick guide.
10. Connect the vapor gas hose H to the
starboard top cowling lock.
11. Connect the PTT motor leads I, and
then fasten them.
12. Connect the positive battery cable J and
negative battery cable K along the bot-
tom of the bottom cowling a.
5-75
Power unit
F
D
C
S6P25C80E
H
S6P25C90E
I
a
NOTE:
To wire the battery cables, see Chapter 8,
"Wiring harness routing."
PTT motor lead bolt:
4 N·m (0.4 kgf·m, 3.0 ft·lb)
Positive battery cable bolt:
18 N·m (1.8 kgf·m, 13.3 ft·lb)
Negative battery cable nut:
13 N·m (1.3 kgf·m, 9.6 ft·lb)
13. Connect the fuel hose.
14. Install the grommet with the speedome-
ter hose L, fuel hose M, positive battery
cable J, negative battery cable K, shift
cable N, gauge harness O, throttle
cable P, and 10-pin main harness Q.
15. Install the cable holder R and retaining
plate S.
K
J
S6P25D00E
6P23H11