SELVA MARINE Blue Whale 250 EFI Service Manual page 89

4. Check that the remote control lever is in
the fully closed position of the throttle,
and then check the output voltage of TPS
1 and the throttle valve opening angle.
CAUTION:
Do not loosen the throttle stop screw nut,
and do not turn the throttle stop screw.
NOTE:
• Check the TPS after the engine has been
warmed up.
• When checking the TPS, do not start the
engine.
• The actual TPS output voltage and throttle
valve opening angle may vary according to
environmental conditions and engine tem-
perature.
6P23H11
5. Shift the remote control lever to the fully
S6P24150
open position and hold it.
S6P24440
6. Check the output voltage of TPS 2 and
the throttle valve opening angle.
7. Operate the remote control lever, and
check that the output voltages of TPS 1
and TPS 2 change continuously.
Output voltage of TPS 1 with the
remote control lever at the fully
closed position:
at 20 °C (68 °F):
0.750 V (reference data)
Throttle valve opening angle with the
remote control lever at the fully
closed position:
at 20 °C (68 °F):
0.5–7.0° (reference data)
TPS 2 output voltage with the remote
control lever at the fully open
position:
at 20 °C (68 °F):
4.550 V
Throttle valve opening angle with the
remote control lever at the fully open
position:
Above 80° (reference data)
Hose routing
1
2
3
4
5
S6P24160
6
7
8
9
4-6