Propeller Shaft Housing (Regular Rotation Model); Removing The Propeller Shaft Housing Assembly; Disassembling The Propeller Shaft Assembly; Disassembling The Propeller Shaft Housing - SELVA MARINE Blue Whale 250 EFI Service Manual

Removing the propeller shaft
housing assembly
1. Remove the water pipe 1 and shift rod
2.
2. Remove the bolts 3, ring 4, and bolts
5.
3. Pull out the propeller shaft housing, and
then remove the propeller shaft.
NOTE:
Before removing the propeller shaft from the
lower case, remove the shift rod.
Bearing housing puller claw L 6:
90890-06502
Stopper guide plate 7: 90890-06501
Center bolt 8: 90890-06504
6P23H11

Propeller shaft housing (regular rotation model)

Disassembling the propeller shaft
assembly
1. Remove the spring 1, and then remove
the cross pin 2, dog clutch 3, shift
plunger 4, slider 5, and shift rod joint
6.
Disassembling the propeller shaft
housing
1. Remove the reverse gear and reverse
gear shim(s).
Bearing separator 1: 90890-06534
Stopper guide plate 2: 90890-06501
Stopper guide stand 3:
90890-06538
Bearing puller assembly 4:
90890-06535
1
2
3
4
5
6
7
8
9
6-8