SELVA MARINE Blue Whale 250 EFI Service Manual page 181

E
NOTE:
• Install the bearings in their original posi-
tions.
• Insert the projection f of each bearing into
the slots in the cylinder block.
6. Set the crankshaft A, new oil seal B,
and thrust bearings C into the cylinder
block as shown.
CAUTION:
Do not damage the oil seal when installing
it by contacting the edge g of the drive
sprocket.
NOTE:
• Apply engine oil to the inner oil seal and the
thrust bearings before installation.
• Do not get any engine oil to the drive
sprocket.
7. Install half of the main bearings D and
the thrust bearing E into the crankcase.
6P23H11
0
9
f
S69J5F10
8. Apply sealant to the mating surface of
the crankcase.
NOTE:
• Install the main bearings in their original
positions.
• Insert the projection h of each bearing into
the slots in the crankcase.
• Do not get any sealant on the main bear-
ings.
Cylinder block
1
2
3
4
5
6
7
8
9
5-68