Assembling The Propeller Shaft Housing - SELVA MARINE Blue Whale 250 EFI Service Manual

Assembling the propeller shaft
housing
1. Install the needle bearing into the propel-
ler shaft housing to the specified depth.
NOTE:
• Install the needle bearing with the manufac-
ture identification mark a facing toward the
oil seal (propeller side).
• When using the driver rod, do not strike the
special service tool in a manner that will
force the stopper c out of place.
Driver rod SS 1: 90890-06604
Needle bearing attachment 2:
90890-06610
Bearing depth plate 3: 90890-06603
Depth b:
25.3 ± 0.25 mm (1.00 ± 0.01 in)
2. Apply grease to the new oil seals, and
then install them into the propeller shaft
housing to the specified depth.
NOTE:
Install an oil seal halfway into the propeller
shaft housing, then the other oil seal.
6P23H11
Propeller shaft housing (counter rotation model)
Bearing inner race attachment 4:
90890-06640
Depth d:
5.0 ± 0.25 mm (0.20 ± 0.01 in)
3. Install the original shim(s) 5 and thrust
bearing 6 with the propeller shaft into
the propeller shaft housing.
NOTE:
• Be sure to select the propeller shaft shim(s)
if replacing the propeller shaft, propeller
shaft housing, thrust bearing or taper roller
bearing.
• To select the shims, see "Shimming
(counter rotation model)."
1
2
3
4
5
6
7
8
9
6-40