Installing The Propeller Shaft Housing; Installing The Water Pump And Shift Rod - SELVA MARINE Blue Whale 250 EFI Service Manual

LOWR
4. Install the drive shaft and drive shaft
housing into the lower case, then the pin-
ion, washer and pinion nut, and then
tighten the nut to the specified torque.
NOTE:
To install the pinion nut, push down on the
drive shaft.
Drive shaft holder 6 5: 90890-06520
Pinion nut holder 6: 90890-06715
Pinion nut:
142 N·m (14.2 kgf·m, 104.7 ft·lb)
5. Tighten the drive shaft housing bolts.
NOTE:
Apply LOCTITE 572 to the drive shaft hous-
ing bolts before installation.

Installing the propeller shaft housing

1. Set the shift rod joint and dog clutch to
the neutral position as shown.
2. Apply grease to the new O-rings and pro-
peller shaft housing.
3. Install the dowel and propeller shaft
housing assembly into the lower case.
6-49
Lower unit
5
6
S63P6310
4. Install the washer and propeller shaft
housing bolts 1, and then tighten the
bolts to the specified torque.
5. Install the ring 2 and bolts 3.
Propeller shaft housing bolt 1:
30 N·m (3.0 kgf·m, 22.1 ft·lb)
6. Install the water pipe and rubber seals.
Installing the water pump and shift
rod
1. Install the shift rod assembly 1.
D
S6P26190E
6P23H11