SELVA MARINE Blue Whale 250 EFI Service Manual page 281

17. Place the PTT unit in an upright position.
18. Remove the reservoir cap 4, and then
check the fluid level in the reservoir.
WARNING
Make sure that the trim and tilt rams are
fully extended when removing the reser-
voir cap, otherwise fluid can spurt out
from the unit due to internal pressure.
NOTE:
If the fluid is at the correct level, a small
amount of fluid should overflow out of the
filler hole when the cap is removed.
19. If necessary, add sufficient fluid of the
recommended type to the correct level.
20. Install the reservoir cap 4, and then
tighten it to the specified torque.
Reservoir cap 4:
7 N·m (0.7 kgf·m, 5.2 ft·lb)
6P23H11
PTT unit
1
2
3
4
5
6
7
8
9
7-26