Bridge Mode Application - Icom VE-PG2 Instruction Manual

1

BRIDGE MODE APPLICATION

■ U������� ����� ����������� U������� ����� �����������
In the Unicast mode, the VE-PG2 specifies a port number, IP address and calls a
specified transceiver that is connected to the VE-PG2.
The following descriptions are based on the step by step example shown below.
Example: Operating VE-PG2 in local area network.
Transceiver A1
If you connect the VE-PG2 to a global network (internet),
you can communicate anywhere through the IP network
without using hub.
Transceiver B1
6
Turn the transceivers' power ON, and
then set the Transceiver A2's volume
control to the 12 o'clock position.
CAUTION:
To connect the transceivers or repeaters, use only the following cables:
OPC-2073 (For the transceivers) or OPC-2074 (For the repeaters).
Connect the specified cables to [TRX1], [TRX2] or [TRX3] only.
Using another cable, like an Ethernet cable may damage the VE-PG2,
transceivers or repeaters.
[TRX1]
Connect to the transceiver A2's speaker jack.
NOTE: First, connect the transceiver
Transceiver A2
to the VE-PG2 using the optional
[TRX1]
OPC-2073. Then turn ON the power
(Port number: 21500)
to the transceiver and the VE-PG2.
Turn the transceivers' power ON, and
then set the Transceiver B2's volume
control to the 12 o'clock position.
CAUTION:
To connect the transceivers or repeaters, use only the following cables:
OPC-2073 (For the transceivers) or OPC-2074 (For the repeaters).
Connect the specified cables to [TRX1], [TRX2] or [TRX3] only.
Using another cable, like an Ethernet cable may damage the VE-PG2,
transceivers or repeaters.
[TRX1]
VE-PG2
192.168.0.3
Connect to the transceiver B2's speaker jack.
Transceiver B2
[TRX1]
(Port number: 21500)
[LAN]
VE-PG2
192.168.0.2
[Area B]
[LAN]
[TRX2]
NOTE: First, connect the transceiver
to the VE-PG2 using the optional
OPC-2073. Then turn ON the power
to the transceiver and the VE-PG2.
[Area A]
1 2 3 4 5
HUB
Transceiver B3