7562
HTU output option solenoid removal
1.
Remove the rear standard bin cover. See
2.
Disconnect the output bin solenoid cable (A).
Note: Tie a string to the cable so you can route the new cable through the HTU.
3.
Remove the front standard bin cover. See
4.
Disconnect the plunger (B) from the stopper diverter, and the spring (C) from the solenoid.
5.
Remove the two screws (D). and then remove the solenoid.
4-390
Service Manual
"HTU rear standard bin cover removal" on page
"HTU front standard bin cover removal" on page
Previous
4-394.
Next
Go Back
4-374.