Finisher or stacker media stack flap and media stack flap actuator removal
See
"Finisher/High-capacity output stacker assembly (continued)" on page 7-39
1.
Remove the option from the printer.
2.
Remove the top cover. See
3.
Use plyers to straighten the locking tab (A) of the actuator you are replacing, and then slide the actuator to
the right to remove it.
Installation note: Use a flat-blade screwdriver to bend the locking tab back into place after you position the
actuator.
"Finisher or stacker top cover removal" on page
7562
for the part number.
4-359.
4-341
Repair information
Previous
Next
Go Back