Xx-Black Cartridge Motor Error Service Check - Lexmark X792 Service Manual

141.xx—Black cartridge motor error service check
Step Questions / actions
1 Turn the printer off, open the system board
shield, and remove the RIP card shield.
Check the cable in the connector JKI1 for
proper connection to the system board.
Is the cable properly connected?
2 Check the cable for damage.
Is the cable damaged?
3 Measure the resistance across the fuse F10
on the system board.
Is the fuse blown?
Yes
Go to step 2.
Replace the BLDC K ITU
cable. See "EP drive
assembly removal" on
page 4-54.
Replace the system board.
See "System board
removal" on page 4-149.
7562
No
Reseat the cable.
Go to step 3.
Go to step 4.
2-89
Diagnostic information
Previous
Next
Go Back