Lexmark X792 Service Manual page 454

7562
•
Place the slot in the ITU DS roller plate over the ridge on the frame, and then swing the plate into place to
reattach the two screws.
•
Check the alignment of the reference edge. See
page 4-145.
Notes:
•
•
•
4-144
Service Manual
When installing the staging paper path reference edge, do not turn the adjustment screw
during installation.
Do not replace, or adjust the printhead and the staging paper path reference at the same time.
See "Pick arm stuck down service check" on page 2-191
original position.
"Staging paper path reference edge adjustment" on
to put the pick arm back to its
Previous
Next
Go Back