Cartridge Memory Block Removal - Lexmark X792 Service Manual

7562

Cartridge memory block removal

See "Front" on page 7-7
1.
Remove the ITU assembly. See
2.
Remove the system board shield. See
3.
Disconnect the cable (A, B, C, or D) for the memory block you want to remove. The terminals are
interchangeable, so trace the cable back from the memory block to locate the correct connector.
Note: To easily route the new cable to the system board, tie a string (at least twelve inches long) to the end of
the cable you disconnect from the system board. When you pull the cable through the printer, be careful to leave
the other end of the string on the system board side, and then untie the string from the cable.
4-40
Service Manual
for the part number.
"ITU assembly removal" on page
"System board shield removal" on page
4-72.
4-29.
A C
D
B
Previous
Next
Go Back