Lexmark X792 Service Manual page 51

Additional checks—202–203 paper jams
Error code Description
202.01 Exit sensor is made when printer tries
to print from an idle state.
Possible causes:
202.02 Exit sensor is made early.
Possible causes:
202.03 Exit sensor is never made.
Possible causes:
202.04 Exit sensor broke early.
Possible causes:
202.05, Exit sensor never broke.
202.07
Possible causes:
202.08 Exit sensor is never made.
202.31 Bin-full sensor active when printing
started.
Possible causes:
202.32 Bin-full sensor is made early.
Possible causes:
• Damaged paper exit sensor or
paper exit sensor flag
• Damaged fuser autoconnect
• Faulty fuser
• Faulty system board
• Incorrect paper settings
• Defective exit sensor
• Improper paper loading
• Paper wrapped in fuser
• Damaged paper exit sensor or
paper exit sensor flag
• Damaged fuser autoconnect
• Faulty fuser DC cable connection
• Faulty fuser
• Faulty system board
• Damaged paper exit sensor or
paper exit sensor flag
• Faulty fuser
• Faulty system board
• Damaged paper exit sensor or
paper exit sensor flag
• Faulty fuser
• Faulty system board
• Faulty output bin flag
• Paper jam leaving paper over the
sensor
• Damaged bin-full sensor
• Faulty system board.
• Incorrect paper settings
• Defective bin-full sensor
Action
1. Check for anything in the paper path that might
cause the paper to jam.
2. The fuser exit sensor may not be functioning
properly. Go to "121.xx—Fuser error service
check" on page 2-79.
1. Check for anything in the paper path that might
cause the paper to jam.
2. If clearing the jam does not solve the problem,
go to "121.xx—Fuser error service check" on
page 2-79.
1. Check for anything in the paper path that might
cause the paper to jam.
2. The fuser exit sensor may not be functioning
properly. Go to "121.xx—Fuser error service
check" on page 2-79.
The fuser exit sensor may not be functioning
properly. Go to "121.xx—Fuser error service
check" on page 2-79.
1. Check exit sensor flag on fuser for proper
operation.Be sure the paper is not hanging on
the flag.
2. The fuser exit sensor may not be functioning
properly. Go to "121.xx—Fuser error service
check" on page 2-79.
See "202.03" on page 2-11.
1. Clear away anything in the paper path that might
cause the paper to jam.
2. Be sure the paper settings match the media.
3. Flex the media, and stack it flat in the tray.
4. Properly set the paper guides in the paper tray.
5. If the problem persists, go to
down service check" on page
1. Check for anything in the paper path that might
cause the paper to jam.
2. If clearing the jam does not solve the problem,
go to "202.32—Paper Jam error service
check" on page 2-115.
Diagnostic information
7562
Previous
Next
Go Back
"Pick arm stuck
2-191.
2-11